Steering grip attachment
OTEDAMA OT-H1 (For steering controllers)

---

Details
It is a one-pair grip attachment on the left and right that becomes a "OTEDAMA type steering" when attached to the steering controller. A special adhesive is used for the mounting adhesive, so it can be removed cleanly.

Corresponding type : Steering controllers　G26 G27 G29 T-300 etc.
Wheel diameter : 28cm ±3cm
Cross section size : 35mm X 27mm　(±4mm X ±4mm)
Material : TPU(3D-Printer)

An example of attaching "OTEDAMA OT-H1" to a commercially available steering controller.

How to install

1. Temporarily fix the attachment so that the distance shown in the figure from the center of the wheel is about 70 mm.
2. Attach a cable tie so that it acts as a stopper at the position where it comes into contact with the attachment.

3. Remove the attachment and pour an appropriate amount of the attached adhesive inside the attachment.
4. Slowly attach the attachment to the wheel from the end.

5. Adjust the attachment position so that it touches the binding band of the stopper while moving the adhesive back and forth and left and right so that it fits in the wheel.
6. After attaching the left side in the same way and checking the left and right balance, remove the stopper and leave it for a whole day to complete.